Can I connect my quip Ultra brush with the quip app?Updated 41 minutes ago

You can!

After signing into the quip app, you can pair your brush by following the steps listed below:

1. Click “Start pairing” to begin onboarding (You'll need to be logged in first!)
2. Power your brush on and then off. After completing this action, select “OK, I did it”
3. Any brushes in range will now appear in the pairing screen. Please select the brush you would like to pair!
4. Once selected, the brush you would like to pair will vibrate for about 3 seconds
5. If the brush that vibrates is the correct brush, click “Yes, pair this brush”
6. If the brush that vibrates is not the brush you are looking to pair, please select another brush
7. Once you click “Pair your brush” you will be prompted to continue onboarding where you will be prompted to name your brush. Continue to click through and follow the on-screen instructions until you reach the “Start brushing” page

-----------

This appliance is not intended for use by persons (including children under the age of 3) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Close supervision is necessary when this product is used by or on, or near children or persons with disabilities.

Model: S

FCC ID: 2AT6D-S

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. and (2) this device must accept any interference received, including interference that may cause undesired operation.Pursuant to FCC 15.21 of the FCC rules, changes not expressly approved by quip NYC, Inc. might cause harmful interference and void the FCC authorization to operate this product.This product complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an output on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.