How do I use my Water Flosser?Updated 2 months ago

Before you get started, make sure to fully charge your Rechargeable Cordless Water Flosser, using your USB magnetic charging cable. 

Next, remove the Floss Tip (stored inside the Water Tank) and snap it into place. 

Open the reservoir hatch, fill with lukewarm water^*, then close the lid. Please be sure to keep the lid of your Water Flosser snapped shut when in use to prevent less mess.

Tip: Make sure to use only lukewarm water to avoid temperature shock to your teeth!

We do not advise using any other forms of liquid as it may cause damage to the flosser’s internal systems and void any warranty coverage.

To find your flow, close your lips slightly around the floss tip and lean over your sink. Lightly press the “q” button for on-demand water flow, or press and click for a steady stream. Press again to turn off.

For a complete clean, start in one quadrant of your mouth, and floss one tooth at a time (~2 secs each) along the gum-line, front/back, and in between. Be sure to repeat these steps in all four quadrants! You’ll want to be extra careful not to floss with the Floss Tip pressed directly against your gums as this will trigger the automatic shut-off sensor. (And can also damage your gums!)

To customize your clean, press the bottom LED button to switch pressure mode from gentle (white light) to deep clean (blue light). Once complete, empty tank & let fully air dry.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Close supervision is necessary when this product is used by or on, or near children or persons with disabilities.